Most Ella walk-in tubs stand between about 35 and 40 inches from the floor to the top of the deck, and the exact height for your model is the actual size figure on its spec sheet. A shower column adds its own height on top of that, measured upward from the deck, so the installed height is the deck height plus the column height. Use the deck height alone for windows, vanities and countertops, and the combined height for ceilings and anything mounted above the tub.
Reading the Height on the Spec Sheet
Spec sheets list the tub's actual size as width by length by height, alongside shipping figures for the crated tub. If a height figure looks taller than you expect, check that you are reading the actual size line and not a shipping dimension. Examples the team quotes from current sheets:
- Elite: the deck runs level all the way around at 34 3/4 inches. The neck rest at the head end is the only point that rises higher, and the spec sheet's overall height of 35 inches is taken there.
- Mobile 26 by 45: 39 inches, just under 40.
- Big4One: 39.5 inches.
The seat height and the step-over threshold height are printed on the same drawing, which is where to look if you are deciding on a model; seat sizes and soaking depth explains how to use them.
Deck Height Next to Windows and Counters
The deck is the highest structural point of the tub, so compare it directly with your window sill or countertop. On the Elite, for instance, the deck sits at the same 34 3/4 inches where it meets the wall as it does at the door, so a vanity on either side lines up with the deck, not with the taller neck rest. Shorter tubs include an extension panel to close the gap in an alcove, and what an alcove installation is shows how that panel meets the walls. If a sill sits lower than the deck, read checking tub height before you order before choosing a model.
Adding a Shower Column
The shower column mounts on the tub deck and its published height is measured from the deck, not from the floor. To find the finished height, add the column figure to your model's deck height. The column reaches up to 64 inches above the deck at its tallest setting, so on a taller tub the fully extended column can run close to or above a typical bathroom ceiling. Measure your ceiling and any soffit or sloped section above the tub, and confirm the column dimension for your order with your Ella dealer or the team at (800) 480-6850 before you commit. The column is not offered for the LayDown models. Options for showering, including the pull-out hand shower on the 5-piece Fast-Fill faucet, are compared in hand showers, shower columns and screens, and the wall-mounted alternative is in installing the hand shower slider bar.
Getting a Full Dimension List
Product pages show only width and length in the headline. The spec sheet on the Downloads tab, and the specification included with your order paperwork, list every measurement: height, seat height, threshold, door opening and drain position. Ask the team to email the sheet for any model you are comparing.
Related Guides
- Lowering the Tub: Below-Subfloor Drains, 3 Inch Thresholds, and What It Does to the Warranty
- Installing the Shower Column Kit on Your Walk-in Tub
- What Size Water Heater Do I Need for My Walk-in Tub?
Related Videos
Chapters in this video
- 0:00 Installing the Shower Column Base The technician inserts the shower column base into the pre-drilled hole and secures it with washers and a locking collar.
- 0:37 Attaching the Riser Tube The technician screws the riser tube onto the shower base unit, ensuring the gasket is correctly placed.
- 0:50 Connecting the Shower Supply Line The technician connects the shower supply line to the bottom of the base unit and then to the diverter.
- 1:13 Adjusting the Riser Arm Bracket The technician adjusts the riser arm bracket to accommodate various wall configurations and places the rubber gasket.
- 2:04 Mounting the Shower Column The technician attaches the mounting brackets to the shower wall, ensuring the unit is perfectly level.
- 2:22 Attaching Rain and Hand Showers The technician attaches the rain shower to the riser tube and the hand shower to the unit with a flexible hose.
Watch: Ella's Bubbles Shower Column Installation With A 5 Piece Faucet Set with chapters and a full transcript.
Chapters in this video
- 0:00 Install Shower Column Base The technician removes the hand shower and installs the shower column base unit into the pre-drilled hole.
- 0:40 Connect Shower Column Feed Line The technician connects the shower column feed line to the bottom of the shower column and the faucet.
- 1:14 Install Riser Tube And Wall Mount The technician installs the riser tube and secures the brass wall mount with a chrome collar and gasket.
- 1:33 Attach Upper Mounting Bracket The technician attaches the upper mounting bracket, ensuring the shower riser is vertical, and inserts the column's mounting arms.
- 1:54 Connect Hand Shower Hose The technician attaches the adapter nut to the shower column and connects the hand shower hose to the adapter nut.
Watch: Ella's Bubbles: Shower Column Installation With A 2 Piece Faucet with chapters and a full transcript.
Watch: Ella Walk-In Tub with Shower Column: Perfect for Safe & Stylish Bathing on its own page.
Common Questions
Why does the spec sheet show two different heights?
Is the Elite deck the same height all the way around?
How high does the tub reach with a shower column installed?
Can I put a shower column on a LayDown tub?
Where do I find the seat and threshold heights?
Still Need Help?
Open a ticket at ellasbubbles.com/support or call (800) 480-6850 and have your model and serial number ready.