Support Center / Warranty & Registration / Where Is the Serial Number on a Walk-In Tub That Is Already Installed?
Back to Warranty & Registration

Where Is the Serial Number on a Walk-In Tub That Is Already Installed?

On an Ella walk-in tub that is already installed, the serial number is on a label behind the magnetic access panel next to the door, so you can read it without moving the tub or disturbing the plumbing. The manual is a good place to record the number, but the number itself is read from the tub. If the paperwork is missing as well, I Did Not Receive an Owner's Manual for My Walk-In Tub. Where Do I Get One? explains how the team sends replacement documents once you have that number.

Where to Look on a Tub That Is Already in Place

The good news for an installed tub is that the label was placed where it stays reachable after the walls are finished. The front of every Ella walk-in tub carries a removable apron, typically with two easily removable panels that give service access to the plumbing and the other components. The serial label sits behind the magnetic access panel next to the door. Nothing has to be uncaulked, cut or pulled away from the wall to see it.

The short video on this page, Ella's Bubbles: Serial Number Location, shows the same thing from the factory side. It explains that the serial number is located on the inside of one of the removable panels. Putting the two together gives you a simple routine:

  1. Stand at the front of the tub and find the access panel beside the door.
  2. Remove that panel and set it down with its inside face toward you.
  3. Look for the label on the inside of the panel and in the opening behind it.
  4. Photograph the whole label in good light, close enough that every character can be read.
  5. Put the panel back the way it came off.

If the panel next to the door does not show a label, check the inside of the other removable front panel before you assume the label is gone.

If the Panel Does Not Lift Away Easily

How the apron attaches varies by model. Depending on the tub, the panels are held with clips, screws, velcro tape or magnets. On the Standard and Zen platform, for example, the two front access panels are held with screws that sit under white screw caps, so the caps come off first and the screws second. If your panel does not release with a gentle pull, look for caps or fasteners along its edges instead of forcing it.

The front access panels are also a different part from the trim at the bottom of the apron. The strip between the front panel and the floor is the toe kick panel, described in Gap Between the Front Apron and the Floor: The Two Inch Toe Kick Panel and When to Trim It. The serial label is not there, so there is no need to remove that strip to find it.

What the Label Tells the Team

The video calls the serial number an important piece of information, and it says why. The information on the label lets the team see three things about your individual tub:

  • when the tub was made,
  • who made it,
  • which replacement parts are compatible, should there ever be an issue.

That is what makes the serial number more useful than a description. Manuals and electrical diagrams are written per tub family and therapy package, and the operating pages differ between them. Two tubs that look alike from the front can carry different therapy packages, and owners who bought a home with a tub already installed often do not know which package they have. The label carries the serial number and the model information the team needs, so one clear photo of it settles which documents and which parts belong to your tub.

Serial Number, Model Number and Where Each One Lives

These two numbers are often confused, and they are found in different places.

  • Serial number: on the label behind the magnetic access panel next to the door. It identifies your individual tub.
  • Model, SKU or UPC: on your proposal or invoice. It identifies what was ordered.

If you have the invoice, you have the model. If you do not have the invoice, which is common for a second owner of the home or when a builder kept the job folder, the label is your starting point because it carries model information along with the serial number. It also helps to note your door style and your control type, push controls or the digital touchpad, since those details help match the right operating pages.

Once the team knows the model, the documents follow. How to Get the Spec Sheet and Manual for Your Ella Walk-In Tub Model covers both routes: downloading the PDFs yourself from the model's page under the Downloads tab, or sending a photo of the label through ellasbubbles.com/support so the team replies with the manual and spec sheet for that exact tub.

When You Will Be Asked for the Serial Number

It is worth reading the label once and keeping the result, because the same number comes up again and again:

  • Warranty activation. The activation form asks for your serial number and model information. What Is the Warranty Activation Form for an Ella Walk-In Tub? explains the two pages, the owner and installer signatures and the copy of the sales receipt that goes with it. If activation slipped past install day, simply complete it now.
  • Replacement documents. A request for the owner's manual, the spec sheet and the cleaning and care instructions goes faster with your model or serial number.
  • Parts questions. When a piece such as the toe kick panel is missing, the team asks for a photo of the front of the tub and your serial number, so the warehouse can confirm what shipped on your unit before a replacement is arranged.
  • Support tickets. For a ticket at ellasbubbles.com/support, have the serial number ready along with your sales receipt and the date of installation.

Some requests need other details instead. An extra end panel, for example, is cut for a specific model and end, so that order needs your model, your door side and which end of the tub is exposed.

Keep a Record so You Only Look Once

After you have photographed the label, store the photo with the rest of the tub paperwork. Keeping a copy of the signed activation form, the sales receipt and a photo of the serial label together means warranty parts, support requests and activation all go faster. If you own a hydrogen tub, its individual test results are worth keeping in the same place.

If the label cannot be found or cannot be read, reach out through ellasbubbles.com/support or call (800) 480-6850, and share clear photos of the tub, the door and the controls along with any proposal or invoice you have. Your Ella dealer can help as well, since the model appears on the order paperwork.

Common Questions

Where exactly is the serial number on an installed Ella walk-in tub?
It is on a label behind the magnetic access panel next to the door. The Serial Number Location video adds that it is located on the inside of one of the removable panels, so check the inside face of the panel as well as the opening behind it.
Do I have to move the tub to read the serial number?
No. The label sits behind a removable front access panel, which is there for service access after installation. You remove the panel, read or photograph the label, and put the panel back.
What does the serial number tell Ella's Bubbles about my tub?
The information on the label lets the team see when the tub was made, who made it and which replacement parts are compatible. That is why the team asks for it before sending documents or confirming parts.
Is the model number in the same place as the serial number?
The model, SKU or UPC appears on your proposal or invoice. The label behind the access panel carries the serial number and model information, so a photo of the label is enough when the paperwork is missing.
What should I do if I bought a house with the tub installed?
Open the magnetic access panel next to the door and photograph the label inside. Send the photo through ellasbubbles.com/support and the team replies with the manual and spec sheet for that exact tub.
Why does the warranty activation form ask for my serial number?
The form puts your Lifetime Limited Warranty on file for your individual tub, so it asks for the serial number and model information. The serial comes from the label behind the access panel, and the model comes from your proposal or invoice.

About this guide. Answers in the Ella's Bubbles Ella's Bubbles Walk-In Tub Support Center are compiled from real conversations with owners, our technicians’ notes and the product documentation, then reviewed by our team. Models and options have evolved over the years, so a detail here may differ slightly from yours. If something looks different on yours, send us your serial number and a specialist will confirm it for your model.

Was this helpful?

Did this solve your question?

If not, open a ticket and our team will pick it up from here.

Open a Support Ticket