Describe a custom shower pan in four parts: the wall layout (a three-wall alcove or a two-wall corner, plus which side is the entry), the length and width of the finished opening in inches, the drain position measured from its center to each wall, and the threshold style you want. A simple drawing showing the walls, the size and the drain ties it all together. The drain rules themselves are covered in Can Ella make a custom shower base with an off-center drain?, and this page is the practical guide to writing your description so the base arrives matching your bathroom.
Start with the Walls and the Entry
The first thing to say is whether your space is a three-wall alcove or a two-wall corner. This comes first because the drain and the finished edges are placed from that. An alcove base sits between a back wall and two side walls. A corner base sits against two walls and has two open sides.
Then note which side is the entry. On a custom base the threshold goes on the longer side, so the entry faces out from the long edge of the rectangle. In a corner, check that the floor in front of that long edge is clear, because that is where you will step in.
One limit to settle at this stage: every Ella base is a rectangle, with no angled or curved edges. If your corner was built for a clipped, diagonal front, the useful question is whether a rectangle can be drawn into it. How do I measure a corner for a neo-angle shower base? shows how to measure that kind of corner for a rectangular base.
Give the Size of the Finished Opening
State the length and the width in inches, in quarter inch increments. Measure the opening the base will fill, along the finished wall surface and not the framing. In a corner, start the tape at the corner and run it along each wall to the point where the base will end. Those two figures become the width and length of the rectangle.
Check your numbers against the published limits before you send them:
- The smallest custom base is 30 by 30 inches.
- A custom three-wall alcove base can be up to 44 inches wide by 80 inches long.
- A custom corner base can be up to 42 by 60 inches.
It is also worth a quick look at the stock sizes first. The standard bases are 30 by 60, 32 by 60 and 36 by 60 inches with a left or right drain in a set position for each size. If one of those fits your opening and your drain, it is the simplest choice. Where can I buy a custom-sized shower base for my bathroom? compares the stock and custom routes.
Describe the Drain Position
For the drain, say left, right, center or a custom position. If you are matching a pipe that is already in the floor, do not estimate. Find the existing drain line and measure from its center to each wall, then write both figures down and mark which wall each one is measured from.
Keep one rule in mind while you measure: a custom drain cannot sit closer than 9 inches to the back wall or the side wall. A drain only 7 inches from the threshold edge, for example, is not possible even on a custom base. If your existing pipe falls inside that margin, the options are to choose a drain position that does fit and have a licensed plumber relocate the line, or to look again at the layout. It is far better to find that out with a tape measure than after the base is built.
When you write the drain position, be specific about your point of view. Left and right should be given as you face the shower from the entry side, and your drawing should show the same thing so there is no room for doubt.
Add the Threshold Style and a Drawing
The threshold is the edge you step across at the entry, which many people call the curb. Say which style you want, and your Ella dealer or the team at (800) 480-6850 can confirm which threshold style suits your bathroom and how it meets your plumbing rough-in. The threshold, the slope and the drain are all molded into the acrylic, so the base is finished when it arrives and must not be tiled over. Does Ella Make a Neo-Angle Shower Pan With a Curb for Corners? walks through the threshold choices for a corner.
Then put everything into one request. A complete description includes:
- Alcove or corner, and which walls are finished walls.
- The entry side.
- Length and width of the finished opening in inches, to the quarter inch.
- Drain position: left, right, center or custom, with the distance from the drain center to each wall.
- The threshold style you want.
- A simple drawing of the walls, the size and the drain position.
The drawing does not need to be to scale or professionally made. A hand sketch with the walls labeled, the two dimensions written along the edges and the drain marked with its two measurements is exactly what is needed. Send it with your request at ellasbubbles.com/support, or share it with your Ella dealer or the team at (800) 480-6850.
Check Everything Before the Order Is Placed
Custom orders are built to the values you submit, and they are final once paid. That makes a second look worthwhile:
- Measure the opening twice, at the finished wall surface.
- Confirm the footprint is a true rectangle with no angled or curved edge.
- Confirm the drain center is at least 9 inches from the back wall and the side wall.
- Confirm the long side is the side you want to enter from.
- Have your installer or plumber review the drawing against the pipe in the floor.
When the base arrives, check it against your drawing before any demolition. The shower installation video on this page makes the same point for Ella's modular showers: confirm you have received the correct drain location and that everything is free from damage before you move into the bathroom, and delay removing the existing tub or shower until you are confident the new unit is the correct size and condition. That way the bathroom stays usable until everything is confirmed.
For layouts that seem too unusual to describe, Who makes custom shower pans for odd bathroom layouts? lists the kinds of spaces a custom rectangle can solve.

Watch: Step-by-Step Low-Threshold Shower Installation for Remodeling | Ella’s Bubbles with chapters and a full transcript.
Related Guides
- Custom-Size Shower Bases: Size Ranges, Threshold Options, Drain Placement Rules, Construction, and How to Request One
- How Do I Measure My Bathroom for a Shower Pan or Shower Base?
- What Specs Should I Check Before Ordering a Shower Base?