Why Is Water Appearing at the Bottom of My Walk-In Tub Door?

Water at the bottom of a walk-in tub door while the tub is full usually means the door is not pressing evenly into its seal along the bottom edge, and the cause is more often a leveling leg that is not carrying weight or a seal that has shifted in its channel than a failed gasket. Water that shows up only after you drain and open the door is drainage, not a leak, and is normal. The timing test that separates the two is in Water on the Floor After a Bath: Door Leak or Drain Leak?, and the sections below take the bottom edge and the bottom striker one cause at a time.

First, Confirm It Is a Leak and Not Drainage

Fill the tub with the door closed and locked, then watch the outside of the door frame, the sill and the floor while the tub is full. Dry while full means the seal is doing its job. Anything you see after draining is water running off the inside face of the door, out of the gasket and down the sill, which happens whenever an outward-swing door opens after a bath and can run into the latch openings in the jamb. On a brand new tub this surprises people, and it is not a fault.

Three other things look like a bottom-of-door leak and are not:

• A little water sitting below the drain plug after draining. That is the trap, which holds water so sewer gas cannot come back up. The level stays the same rather than rising, and the tub floor around the drain is dry once draining finishes.
• A few drops on the floor beneath the tub under the striker plate after draining. The opening where each locking pin seats is not sealed underneath, and Ella tubs are not equipped with a drain for it, so water that collects in the door track can pass through that hole. No part is missing. If the drip bothers you, or the tub sits over a finished ceiling, a licensed plumber can fit a catch and hose under that opening.
• Water that runs down the outside of the door on the hinge side only while the jets or the hand shower are running. That is spray funneled into the gap between the door and the tub by a 4-fold shower screen sitting too far out on the deck, and the fix is to move the screen to the inside edge of the deck.

The pattern that needs attention is a steady run from the frame or the bottom edge while the tub is full.

Why the Bottom Edge Leaks: Start with the Legs

The number one cause of a door leak is a leveling leg that is not touching the floor. A tub can read level across the deck while one leg floats, because the other legs are holding the frame up. The floating leg lets the shell bow under the weight of the water, which pulls the door frame out of shape and the door out of alignment with its seal. All legs must touch the floor with equal weight distribution or the frame and shell can warp, so this check comes before any seal or latch work.

1. Drain the tub completely and take off the front apron. Any tile or trim over the apron has to come off first.
2. Check every leveling leg by hand. Each one should sit solidly on the floor and carry weight. Adjust any leg that floats until it does.
3. Set a level on the deck and confirm the tub still reads level after the adjustment.

Reseat the Seal and Check the Latch

With the legs set, look at the seal all the way around the door opening. A seal that has shifted off center in its channel leaves a section that the door cannot compress fully. Press it back into its channel the whole way round, then wipe the seal and the door frame clean so nothing sits between them. If the handle no longer pulls the door firmly against the seal, the lock nut behind the apron adjusts how hard the door closes; tighten it until the handle pulls the door snug against the seal without forcing. From then on, complete the full handle turn every time you close the door, because a door that is only partly latched does not compress the seal evenly.

On Transfer Tubs: The Bottom Striker and the Two Pins

The Transfer family's L-shape door locks with two tapered pins that drive out of the latch edge into a striker plate on the frame, and it is the lower pin and striker that searches about water at the bottom striker are asking about. What Is a Striker Plate on a Walk-In Tub Door? explains the part. Open the door, turn the handle to the locked position and look at the two pins. Each should extend about 1 1/2 inches. A bottom pin that sits noticeably shorter than the top one means the pins have skipped a gear inside the door, so the bottom of the door is not being pressed into the gasket as hard as the top, and water finds that end first. The bottom pin can be adjusted on its own.

Then put a hand on the striker plate. It should not move. If it wobbles, tighten it; the striker plate nuts are reached from inside the front apron. Confirm both pins enter the striker cleanly when you lock the door. If the plate still wobbles or shows a crack at the weld, photograph it with a tape measure in the frame, because a failing weld is replaced as a warranty part once the team has reviewed the photos. Never open the door until the tub has drained, and never lean on the door. On a newly installed tub the same three checks, pins, seal and legs, are walked through in Why does water seep at the door striker on a new level tub?.

When the Water Is Not Really Coming from the Bottom

Watch where the water first appears as the tub fills, because two other leaks run down to the bottom edge and get blamed on it. If water appears at or just below the handle while the bottom edge stays dry, it is following the handle screws through the door panel. That is fixed by removing the screws, resealing them with silicone and reinstalling them, and Ella's technical support recommends doing that and testing before ordering a new seal, as Water Leaking From the Door Handle Screws explains. If the water starts at the hinge side and keeps coming after the hinges have been reset, it is getting in behind the bottom hinge and along its bolts, and the door has to come off so the plate behind the hinge can be resealed. Door Still Leaks at the Hinge After Resetting the Hinges gives those steps.

The Refill Test, and When to Open a Ticket

After any adjustment, close and lock the door, fill to a normal bathing level and watch the gasket line, the bottom edge and both sides for 20 minutes. If the door is dry while full, you are done. If it still leaks after the legs are set, the seal is reseated and the latch is adjusted, the seal itself may be worn, and a replacement ships under the parts warranty once the team has verified the problem. Open a ticket at ellasbubbles.com/support or call (800) 480-6850 with your model and serial number, a photo of the seal around the full door opening, a photo of the level on the deck and a short video of where the water first appears as the tub fills. Ella does not send technicians, so a local licensed plumber does any work inside the apron, and the team can answer that person's questions by phone or email.

Related Guides

• Caring for Your Door Seal: Cleaning, Reseating, and Replacing the Gasket
• Door seal or gasket looks worn, loose, or leaks: care, repair, and replacement
• My Door Rubs the Frame When It Closes: Fixing Tub Bow with the Leveling Legs

Related Videos

Preguntas comunes