Support Center / Door & Seal / How long does a walk-in tub door gasket last, and why does my door leak?
Back to Door & Seal

How long does a walk-in tub door gasket last, and why does my door leak?

The door seal on an Ella walk-in tub is a silicone gasket that compresses when the door is locked. It has no scheduled replacement interval and it is covered by the Lifetime Limited Warranty. When a door leaks, the gasket is rarely the part that failed: leveling is the number one cause, followed by residue on the seal, a section out of its channel and a handle that is not closing the door fully. The short answers are in Common Questions About Walk-In Tub Door Seals, and this page puts the checks in order and ties each one to where the water shows up.

How Long the Gasket Lasts and What Shortens Its Life

There is no published service life for the gasket and no replacement schedule to follow. It is not a wear item that you change on a calendar. It is a flexible silicone loop seated in a channel around the door, and it keeps working as long as it stays clean, seated and flexible. It asks two things of you.

  • Keep it clean. Wipe the gasket and the door frame on a regular basis with a common household cleaner, or with rubbing alcohol if the seal feels tacky or looks slightly out of shape. Residue that builds up, and any debris left in the seal or the frame, can lead to leaks. On inward swing doors, wipe the gasket and the inner frame the same way. No grease, oil or spray lubricant is called for.
  • Leave the door slightly open when the tub is idle. It does not need to be wide open, just not fully latched. A door kept latched holds the gasket under constant compression and can weaken its flexibility over time. The maintenance video on this page closes with this advice: leaving the door open slightly prevents unnecessary compression and extends the gasket's flexibility and life.

If the door has been kept shut and has started to drip, leave it open for about a day, or at the very least overnight, so the seal can reform. Then fill the tub and check the gasket line again. Many leaks clear with this step alone.

Read the Leak by Where the Water Appears

Before you touch anything, fill the tub and watch where the first water shows. The location tells you which check to start with.

  • Low on the handle side of the door. This points to leveling. A leveling leg that has lifted lets the shell flex, and that opens a gap at the gasket, usually on the lower handle side.
  • At or just below the handle, with the rest of the door edge dry. This points to the handle screws, not the gasket. The screws pass through the door panel, and if the seal around them is no longer tight, water follows the screws through the door and drips down the outside. The fix is in Water Leaking From the Door Handle Screws: Reseal the Screws Before Replacing the Door Seal.
  • A drip in one spot along the gasket line. This is often caused by grit or a lifted section somewhere else along the loop, so inspect the whole loop and not only the wet spot.
  • Along the bottom edge of the door. Treat this as a bottom edge door leak, which has its own set of checks, and start with the leveling legs.

Water from the handle screws can run down inside the apron and show up only as a wet floor, so look at the handle area closely before you blame the seal.

The Diagnostic Order

  1. Check every leveling leg. Every leg must sit firmly on the floor and carry equal weight. Try to slide a slip of paper under each foot. If it slides, that leg is not carrying weight. Adjust until every leg is solid and the deck is level in both directions.
  2. Clean the gasket and the frame. Use a common household cleaner or rubbing alcohol. Soap film, hair or grit sitting between the gasket and the frame is a very common cause of a slow drip.
  3. Inspect the full loop. Press any section that has popped out back into its channel along its full length. If a section looks flattened, squeeze it gently between your fingertips and pull it slightly away from the door frame to restore its shape.
  4. Let the seal reform. Leave the door open for about a day, or at least overnight.
  5. Check the handle and latch. See the next section.
  6. Retest. Close the door, fill to a normal bathing level and watch the gasket line for 20 minutes.

How the Handle Can Leave the Door Under-Latched

A good gasket still leaks if the door is not pulled fully closed against it, and the handle decides that.

  • Outward-swing doors. The handle must rotate fully, a full 180 degree turn. It faces away from the hinges when unlocked and toward the hinges when locked. A handle refitted in the wrong orientation leads to improper door closure and leaks.
  • Stainless inward doors. The handle should sit flush to the inside of the tub.
  • Chrome handles with a tension adjustment. The second video on this page shows how the adjustment is reached: remove the front apron, locate the protective cap and take it off. Loosening the locking nut creates less tension for the handle, and tightening it creates more.

If a latch has cracked and the door no longer pulls tight, the latch is the part to report, not the gasket.

Where Silicone Belongs, and When to Ask for a New Gasket

Silicone belongs in one place only: a thin bead inside the gasket channel, to hold a seal that keeps working loose. Allow the silicone to set for 20 minutes before reinserting the gasket, then wait 24 hours for it to dry before the tub is filled. On inward swing doors, the video shows the seal rolled away from the frame and a bead run down the corner where the gasket meets the frame. Silicone never goes across the sealing face. There it holds the gasket away from the frame and stops the door from compressing the seal evenly, which is the situation described in Why Does My Tub Door Still Leak After I Caulked the Seal?

A gasket that is torn, or that will not stay seated after cleaning and reshaping, is a replaceable part. Open a ticket at ellasbubbles.com/support or call (800) 480-6850 with your model and serial number, photos of the door and seal, and a note on where the water appears. A replacement seal ships under the parts warranty after the team verifies the problem. Ella does not send technicians, so a local licensed plumber can do any hands-on work. The care and replacement procedure is covered in Door seal or gasket looks worn, loose, or leaks: care, repair, and replacement.

Watch: Ella's Bubbles: Chrome Door Handle Adjustment with chapters and a full transcript.

Video

Common Questions

How often should a walk-in tub door gasket be replaced?
There is no scheduled replacement interval for the silicone door gasket on an Ella walk-in tub. It is replaced only if it is damaged or will not stay seated, and it is covered by the Lifetime Limited Warranty. Keeping it clean and leaving the door slightly open between baths extends its flexibility and life.
Should I leave the tub door open or latched between baths?
Leave it slightly open whenever the tub is not in use. A door kept latched holds the gasket under constant compression, which can weaken the seal over time. It does not need to be wide open, just not fully latched.
Why does my door leak low on the handle side?
That pattern usually points to leveling, the number one cause of door leaks. A leveling leg that has lifted lets the shell flex and opens a gap at the gasket, usually on the lower handle side. Check that every leg sits firmly on the floor with equal weight before you look at the seal.
What does water at or just below the door handle mean?
Water at or just below the handle, with the rest of the door edge dry, points to the handle screws and not the gasket. The screws pass through the door panel and can let water through if their seal is no longer tight. Reseal the screws with silicone and test the tub before replacing any part.
What should I clean the door gasket and frame with?
Use a common household cleaner on a regular basis, and rubbing alcohol if the gasket feels tacky or looks slightly out of shape. Wipe the door frame too, because residue or debris on either surface can cause a leak. Oils, grease and lubricant sprays are not needed.
How do I request a replacement door gasket for my tub?
Open a ticket at ellasbubbles.com/support or call (800) 480-6850. Have your model and serial number, photos of the door and seal, and a note on where the water appears. A replacement seal ships under the parts warranty once the team verifies the problem.

About this guide. Answers in the Ella's Bubbles Ella's Bubbles Walk-In Tub Support Center are compiled from real conversations with owners, our technicians’ notes and the product documentation, then reviewed by our team. Models and options have evolved over the years, so a detail here may differ slightly from yours. If something looks different on yours, send us your serial number and a specialist will confirm it for your model.

Was this helpful?

Did this solve your question?

If not, open a ticket and our team will pick it up from here.

Open a Support Ticket