Support Center / Therapies & Operation / What Is the Difference Between an Air Bath and a Jetted Tub?
Back to Therapies & Operation

What Is the Difference Between an Air Bath and a Jetted Tub?

An air bath and a hydro jetted tub massage you in two different ways. An air bath pushes air through air jets so it rises through the bath water as a blanket of bubbles, while a hydro jetted tub pumps the bath water itself back out through hydro jets as a moving stream. On an Ella walk-in tub these are two separate systems that can share the same shell, and What Is a Bubble Tub and How Does Air Massage Work? covers the air side on its own.

Two Systems, and Two Different Things Moving Through the Lines

The clearest way to tell the two apart is to ask what travels through the plumbing while the massage is running.

  • Hydro massage. The hydro massage draws bath water through a pump and sends it back out through the hydro jets. An intensity dial on the deck mixes more or less air into that water stream, which is how you make the jet stream stronger or gentler.
  • Air massage. The air massage uses its own air pump. That pump blows air through sealed, fully plumbed lines to the air jets in the seat and between the legs, so only air moves through those lines while the system runs. The air then rises through the water as bubbles.

A note on the words. People searching for an air bath usually mean the air massage, which owners also call a bubble tub. People searching for a jetted tub usually mean water jets, which Ella calls hydro massage. In Ella's own guides, a jetted tub is any tub with a massage system, air or hydro, and the tub with no jets at all is called a soaker. Ella also offers a third system, the Infusion microbubble therapy, which turns the water cloudy with billions of tiny bubbles from a single port.

Air Massage, Hydro Massage and the Other Options Side by Side

OptionWhat moves through the linesHow you control itAutomatic careWhat it means for you
Air massage (air bath or bubble tub)Air only, from its own air pump, to air jets in the seat and between the legsOne push button with three speeds, or the air bubble icon on the digital touchpadAuto Purge starts about 20 minutes after the air pump is turned off and runs for 120 secondsA blanket of bubbles rising through the water
Hydro massage (water jets)Bath water, drawn through a pump and sent back out through the hydro jetsIntensity dial on the deck that mixes more or less air into the streamOzone sterilizationA water jet stream whose power you adjust
Infusion microbubble therapyBillions of tiny bubbles from a single portnot listednot listedWater that turns cloudy with microbubbles
Soaker (no jets)Nothing, there are no jets, pumps or therapy linesNothing to switch onNone neededThe easiest tub to care for, with no monthly vinegar flush

What the differences mean in practice: the air massage surrounds you with bubbles from the seat area, and the hydro massage moves the bath water itself in a stream you can dial up or down. Neither replaces the other, which is why many Ella tubs carry both. If you would rather have still water, the soaker gives you the same tub with a smooth interior, and Soaking Walk-In Tub vs Jetted Tub: Which Is Easier to Maintain? compares the upkeep.

How Each One Is Controlled

The air massage runs from a single push button on the deck. The first press starts it on high speed, the second press drops it to medium, the third press to low, and a fourth press turns the system off. There is no reverse ramp, so pressing through to the third setting is how you reach the softest bubbles. On a tub with the digital touchpad, you touch the air bubble icon once to start, use the plus and minus buttons to change intensity, and hold the icon for two seconds to turn the air off.

The hydro massage is adjusted with its intensity control dial, which changes the power of the jet stream by mixing more or less air into the water.

The push buttons themselves are pneumatic rather than electrical. Pressing one sends a puff of air down a small hose to the control box, which switches the pump on. If that hose works loose at the button or at the control box, the button does nothing, so a loose hose is the first thing to check when one massage goes quiet while the other still runs. The connections video on this page shows the check: the air tube is pushed firmly onto the control box nipple with a twist and push, and the button is lifted out of its housing with a fine flat screwdriver so the lock nut and hose behind it can be secured.

What Each System Does on Its Own After Your Bath

Because the two systems carry different things, they look after themselves in different ways.

  • Air massage: Auto Purge. About 20 minutes after the air pump is turned off, the Auto Purge starts on its own and runs for 120 seconds to blow residual water out of the air lines. It is fully automatic, cannot be stopped, and is normal even if it starts while you are still in the tub. Clearing that water is what helps prevent mildew in the system.
  • Hydro massage: ozone and heat. Running the hydrotherapy jets activates ozone sterilization, which helps keep the tub sanitary. The hydro massage also comes with an in-line water heater.

The two-seat tub video on this page shows both systems on one tub: a three-speed air massage with Auto Purge, a hydro massage with an in-line water heater and intensity control dial, ozone sterilization and the microbubble function.

Upkeep Is the Same Routine for Both

Air and hydro systems are both fully plumbed, so anything in the bath water can travel through the lines. One routine covers whichever system your tub has. Mix 2 cups of white vinegar with 2 cups of water, fill the tub to 1 inch above the highest jets, add the mixture, run the tub for 10 minutes, then drain. Do this once before the first bath and once a month after that. You do not need to flush after every bath. The full explanation is in What Is the Vinegar Flush on a Walk-In Tub?.

The hydro side has one extra monthly job. The pump inlet cover is the suction grate where the hydro pump draws water in, and hair or debris on it is a common reason for weak jets, so clear it and wipe it in the same session as the flush. How Do I Clean and Maintain My Walk-In Tub? puts the whole schedule in one place.

Bath products matter on both systems, with one difference worth knowing. Foaming bubble bath with the air massage on makes excess foam and leaves a soap film in the lines, so use it sparingly and rinse afterward. Bath bombs are left out of any jetted tub. Epsom salts are fine when fully dissolved, and the best practice is to enjoy the therapy first and add the salts for the still soak afterward. The details are in Can I Use Epsom Salts, Bath Bombs or Bubble Bath in My Walk-In Tub?.

Decide Before the Tub Is Ordered

Every Ella therapy system is built into the shell at the factory. Jets cannot be added later, and a jetted tub cannot be turned into a soaker, because the package is part of the shell. That makes the air, hydro or both question one to settle up front.

  • Pumps, the in-line heater and the ozone or Auto Purge equipment sit under the tub, and those systems need a dedicated electrical supply. Your local licensed electrician confirms the supply for the package you choose.
  • An individual air jet cannot be permanently closed off, because removing one lets air escape from the system. If the bubbles feel strong, use the low setting.
  • Some models always include at least one massage system, and most others can be ordered as a soaker.

Your Ella dealer or the team at (800) 480-6850 can confirm which systems a specific model offers, and you can also reach the team at ellasbubbles.com/support.

Watch: How to Secure Air & Hydro Connections in Your Walk-In Tub | Ellas Bubbles with chapters and a full transcript.

Video
Video
Video

Common Questions

Is an air bath the same thing as a bubble tub?
Yes. A bubble tub is the everyday name for a walk-in tub with an air massage system, which is what most people mean by an air bath. An air pump pushes air through fully plumbed lines to air jets in the seat and between the legs, and the air rises through the bath water as bubbles.
Can one walk-in tub have both air jets and water jets?
Yes. The air massage and the hydro massage are two separate systems, each with its own pump, and they can be built into the same tub. The two-seat tub video on this page shows a tub with air massage, hydro massage, ozone sterilization and the microbubble function together.
How do I get the gentlest bubbles from the air massage?
On the push control, the first press is high speed, the second is medium and the third is low, so press to the third setting for the softest bubbles. A fourth press turns the system off. On the digital touchpad, use the plus and minus buttons to change the intensity.
Why does the air system start by itself after my bath?
That is the Auto Purge. About 20 minutes after the air pump is turned off, it starts on its own and runs for 120 seconds to blow residual water out of the air lines. It is fully automatic, cannot be stopped, and is normal even if it starts while you are still in the tub.
Do air jets and hydro jets need different cleaning routines?
No, the same vinegar flush covers both. Mix 2 cups of white vinegar with 2 cups of water, fill the tub to 1 inch above the highest jets, add the mixture, run for 10 minutes and drain, once before the first bath and once a month after that. On the hydro side, also clear the pump inlet cover of hair and debris each month.
Can air or hydro jets be added to a tub later?
No. Every Ella therapy system is built into the shell at the factory, so jets cannot be added afterward and a jetted tub cannot be turned into a soaker. Choose the massage package before the tub is ordered, and your Ella dealer or the team at (800) 480-6850 can confirm what a specific model offers.

About this guide. Answers in the Ella's Bubbles Ella's Bubbles Walk-In Tub Support Center are compiled from real conversations with owners, our technicians’ notes and the product documentation, then reviewed by our team. Models and options have evolved over the years, so a detail here may differ slightly from yours. If something looks different on yours, send us your serial number and a specialist will confirm it for your model.

Was this helpful?

Did this solve your question?

If not, open a ticket and our team will pick it up from here.

Open a Support Ticket