Ella's Bubbles Shower Column Installation With A 5 Piece Faucet Set

after removing the hand shower receptacle use the pre-drilled hole to insert the shower column base remove the rubber washer the metal washer and the locking collar after adding a little silicone insert the unit into the hole attach the washers and locking collar and tighten the set screws making sure not to over torque set the height of the shower column base we recommend a height of 7 inches foreign gasket correctly screw the Riser tube onto the shower base unit hand tighten and then add one quarter to one half turn with a wrench take the one half inch shower supply line and connect it to the bottom side of the base unit and tighten and then add one quarter to one half turn with a wrench take the other side and attach it to the diverter here's how the assembly should look bracket for the Riser arm is designed to fit various widths using an allen wrench you can set the bracket at various depths to best accommodate your wall configuration you can set it to a maximum of two and a half inches out or 1 and 3 8 inches in before attaching the mounting bracket be sure to place the rubber gasket into the mounting plate the assembly should look like this do the same for the upper mounting bracket when mounting the shower column to your shower wall make sure the unit is perfectly level attach the mounting brackets to your shower wall attach the rain shower to the Riser tube to attach the hand shower to the unit take the adapter nut and attach it to the shower column attach the flexible shower hose hand tighten and then secure with a wrench one quarter to one half of a turn foreign shower unit into its holder the final assembly should look like this