Support Center / Sizes, Fit & Measuring / What Are the Overall Exterior Width and Height of an Ella Walk-In Tub?
Back to Sizes, Fit & Measuring

What Are the Overall Exterior Width and Height of an Ella Walk-In Tub?

The overall exterior width and height of an Ella walk-in tub are the first and last numbers in the actual size printed on its spec sheet, and they describe the outside of the tub, not the basin you sit in. The Ella Elite, for example, is 30 inches wide and 35 inches tall on the outside, and the Ella Petite is 27.5 inches wide and 35 inches tall. The full height ranking of the lineup is in Which Ella walk-in tubs stand under 36 inches tall?, and this page stays on one job: showing which published numbers are exterior, which are interior, and what each one is for.

Exterior Figures and Basin Figures Are Two Separate Sets of Numbers

Ella walk-in tubs are published with three outside dimensions: width, length and height. Width is the front to back measurement of the shell, length runs along the wall, and height is the outside wall of the tub measured from the floor to the top of the deck. Those three numbers are the overall size of the tub as it sits in your bathroom.

The inside of the tub is described by a different set of figures, and the one printed for every seated model is the seat width. That is why the same tub can carry two very different width numbers without any contradiction:

  • Ella Elite: 30 inches wide on the outside, with a 22 inch wide seat inside.
  • Ella Petite: 27.5 inches wide on the outside, with a 19 inch wide seat inside.
  • Ella LayDown 30x60: 30 inches wide on the outside, with a flat interior floor 46 inches long by 20 inches wide.

A wall to wall interior basin width is not printed on the current spec sheets for the Elite or the Petite, so the seat width is the interior figure to rely on. The inside of those two tubs is covered in What is the interior basin width of the Ella Elite and Petite tubs?. If a number you have been given seems far too small to be the size of the tub, it is almost certainly an interior figure.

Overall Exterior Width and Height by Model

The table uses only figures printed on the current spec sheets or in Ella's published articles. Where a figure is not available in those sources, the cell says not listed instead of estimating.

ModelOverall exterior widthOverall exterior heightInterior figure publishedWhat it means
Ella Petite27.5 inches35 inches19 inch seat widthThe narrowest seated footprint Ella makes
Ella Elite30 inches35 inches22 inch seat widthA wider seat on the same 35 inch tall platform
Ella Flow28 inches36 1/2 inches20 inch seat widthThe shortest seated tub, for the smallest bathrooms
Ella Royalnot listed35 inchesnot listedShares the lowest seated height with the Elite and Petite
Ella Ultimate 30x60not listed35 3/4 inchesnot listedStill under 36 inches tall on the outside
Ella Deluxe30 inches39 inchesnot listedA taller outside wall than the compact tubs
Ella LayDown 30x6030 inches21 inches at the deck edgeFloor 46 inches long by 20 inches wideThe lowest Ella tub, built for lying back with no seat

What the differences mean: among the seated tubs, exterior height moves within a fairly narrow band, from 35 inches on the Elite, Petite and Royal up to 41 3/8 inches on the HomeCare assisted-bathing tub, while exterior width is what really separates the compact models. The Elite gives you 2.5 more inches of width than the Petite at the same 35 inch height, and that extra width shows up inside as a 22 inch seat instead of a 19 inch seat. The LayDown 30x60 is the exception on height. It has no seat, so its outside wall stands only 21 inches high even though it is as wide as the Elite.

The Size in the Name Is Nominal, so Plan with the Actual Inches

The size in a model's name is a rounded nominal figure. The Petite is the clearest example: it is named as a 28 inch tub, and its actual exterior width on the current spec sheet is 27.5 inches. The Elite's actual exterior width is 30 inches. On the LayDown 30x60, the tub is listed at 30 inches wide by 60 inches long by 21 inches high, and the drawing shows an overall length of 59 3/4 inches.

When you are checking whether a tub will fit, measure every doorway and hallway on the way to the bathroom as well as the alcove itself, and hold those measurements against the actual figures on the spec sheet for your model, not the rounded size in its name.

What the Exterior Height Tells You, and What It Does Not

Overall height is the figure to hold against a window sill, a vanity top or the line where the wall tile stops. It is worth knowing three things about it before you plan around it:

  • It is not the step-in. You enter through a sealed door, and the threshold in the door opening is a matter of a few inches, roughly 3 1/2 to 4 inches on the Capri and 6 inches on the Elite, however tall the shell is. The two numbers are set side by side in How tall are walk-in tubs and how high is the step-in?.
  • It is tall for a reason. A seated walk-in tub has a molded seat at chair height, about 17 inches on most models, with a footwell in front, and the water has to rise around a seated bather. A seated tub cannot be built shorter than 35 inches.
  • The leveling legs do not lower it. The legs plant every foot evenly and keep the door aligned and sealed. They cannot be turned down to make a tub shorter.

If a much lower outside wall matters most, the LayDown models are the ones to look at, because they give up the seat. The LayDown still offers a 15 inch soaking depth, compared with about 11 inches in a standard bathtub. Their interior figures are collected in Which Ella Walk-In Tubs Have No Seat, and How High Is the Interior Wall?.

If Your Model or Figure Is Not Shown Here

Every Ella model has its own spec sheet with the actual width, length and height printed on it, and that sheet is the authority for your tub. If you are unsure which number on a drawing is the outside of the tub, or your model is not in the table above, your Ella dealer or the team at (800) 480-6850 can confirm the actual exterior size for you. You can also send the question through ellasbubbles.com/support. Have the model name ready, and mention whether you are checking a doorway, an alcove or a height limit under a window, so the right figure is confirmed the first time.

Common Questions

Is the width on the spec sheet the outside of the tub or the basin?
It is the outside of the tub. Ella publishes three outside dimensions for each walk-in tub: width, length and height. The inside is described separately, most often by the seat width.
How wide and how tall is the Ella Elite on the outside?
The Ella Elite's actual size is 30 inches wide by 52 inches long by 35 inches tall. Its seat is 22 inches wide, which is an interior figure and not the width of the tub.
Is the Ella Petite really 28 inches wide overall?
The 28 inch figure is the nominal size in the name. The actual exterior width on the current spec sheet is 27.5 inches, and the tub is 52 inches long and 35 inches tall.
Is the overall height the same as the step-in height?
No. Overall height is the outside wall from the floor to the top of the deck. The step-in is the low threshold in the door opening, which is 6 inches on the Elite and roughly 3 1/2 to 4 inches on the Capri.
Can the leveling legs be adjusted to make the tub shorter?
No. The leveling legs are there to plant every foot evenly and keep the door aligned and sealed. They cannot be turned down to lower a tub.
Which Ella walk-in tub has the lowest exterior height?
The LayDown 30x60 is the lowest, at 21 inches high at the deck edge. It has no seat, so it does not need the taller wall of a seated tub, and it still offers a 15 inch soaking depth.

About this guide. Answers in the Ella's Bubbles Ella's Bubbles Walk-In Tub Support Center are compiled from real conversations with owners, our technicians’ notes and the product documentation, then reviewed by our team. Models and options have evolved over the years, so a detail here may differ slightly from yours. If something looks different on yours, send us your serial number and a specialist will confirm it for your model.

Was this helpful?

Did this solve your question?

If not, open a ticket and our team will pick it up from here.

Open a Support Ticket