Support Center / Therapies & Operation / Which Walk-In Tub Keeps the Water Hot at a Set Temperature?
Back to Therapies & Operation

Which Walk-In Tub Keeps the Water Hot at a Set Temperature?

On an Ella walk-in tub, holding the bath warm and setting the fill temperature are two different features, so the tub that does both is one built with a hydro massage package and the Ella thermostatic faucet package. The hydro package brings an in-line water heater that maintains the bath temperature while the hydro pump runs, and the thermostatic package brings a Thermostatic Control Valve that blends hot and cold to a set point at the faucet. What Is a Thermostatic Control Valve (TCV) on a Walk-In Tub? defines the valve, and this page puts both features together so you know what to ask for.

The Features Side by Side

Feature or configurationWhat it does for temperatureFigures listedBest for
In-line water heater (every hydro massage package)Maintains, but does not raise, the bath temperature while the hydro pump runs6A 650W on the Standard, Zen and Flow; 5.5A 650W on the Elite and Petite; 9A 1000W on the Ultimate foot loopStaying warm through a long hydro massage
Ella thermostatic faucet package with TCVBlends hot and cold to a set temperature before the water leaves the faucetFactory-set at 100.4 degrees FahrenheitA steady fill temperature with anti-scald protection
Dual lever 5 piece fast fill faucetNot thermostatic, temperature set by hand with the leversnot listedBathers happy to set the mix themselves
2 piece fast fill faucetNot thermostatic, temperature set by handnot listedBathers happy to set the mix themselves
Waterfall wall mount faucetNot thermostatic, separate hot and cold controls set every timenot listedA wall mount fill where the mix is set by hand
Air only and soaking tubsNo hydro pump, so no in-line heaternot listedShorter soaks filled comfortably hot

What the differences mean for you: neither feature is tied to one model name. The in-line heater follows the therapy package, and the valve follows the faucet package, so two tubs of the same model can behave differently. If keeping warm matters most, make sure hydro massage is on your order. If a fixed, repeatable fill temperature matters most, make sure the thermostatic faucet package is on your order. If you want both, ask for both by name.

Keeping the Bath Warm: The In-Line Heater

Any Ella tub ordered with hydro massage includes an in-line water heater plumbed into the hydro loop. It switches on automatically with the hydro pump and holds a steady temperature while the water circulates through the jets. There is no heater button and no thermostat to set. The first video on this page shows the idea in a few seconds: you set a comfortable temperature at the faucet while filling, and once the hydro massage is engaged, the heater working with the pump maintains a consistent warm temperature.

Three limits are worth knowing before you choose:

  • It maintains, it does not heat. The heater never warms water that arrived cool. Your home water heater sets the starting temperature.
  • It runs only with the hydro pump. With the hydro off, the water cools like any bath, and the air massage has no heater.
  • It cannot be added to soaking or air only tubs. Those configurations have no hydro pump for it to work with.

On tubs with independent foot massage, such as the Ultimate, the heater is attached to the foot massage pump, so running the foot jets is what keeps the water warm on those builds. What Is an In-Line Water Heater on a Walk-In Tub? covers the heater in full, and Why Doesn't the Water Stay Hot and Why Do the Jets Blow Cold? is the page to read if a tub with a heater still seems to cool.

Setting the Temperature at the Faucet: The Thermostatic Valve

To have the temperature set and held at the faucet itself, the feature to ask for is the Ella thermostatic faucet package. It includes a Thermostatic Control Valve, or TCV, a deck-mounted anti-scald valve with its own control handle. Hot and cold supply lines feed into the valve, and a cartridge inside mixes them to the set temperature. If the cold supply drops, the valve limits the hot flow, and if the hot supply drops, it limits the cold, so the water at the spout stays consistent. That matters in a walk-in tub because you cannot step out of the way of a temperature spike until the tub drains.

The valve arrives set at 100.4 degrees Fahrenheit. It is offered on most of our acrylic walk-in tub line, including the Elite, Petite, Royal, Deluxe and Companion. The second video on this page shows the handle up close: the spring-loaded locking pin inside is the anti-scald mechanism, the button springs back when set at 100.4 degrees, and the video shows how the handle is reset for warmer water. Please keep bath water at or below 100.4 degrees Fahrenheit.

As an owner, plan for two things. The TCV carries a 1-year limited warranty, and cartridge sticking caused by calcium, iron or other heavy particles in the water is not covered, which is why an inline filter or mesh on the supply lines is required and must be cleaned periodically. If water ever runs hotter than the setting, Why Is the Water in My Walk-In Tub Too Hot? walks through the checks.

What Your Home Water Heater Has to Do

Because the in-line heater only maintains temperature, every warm bath starts with a hot fill from the house. People often ask what temperature to set the home water heater to for a walk-in tub. The figures our team publishes are about capacity and flow rather than a thermostat setting, because the usual reason for a cool fill is a heater that cannot keep up with the fast fill faucet:

  • Most Ella models: a 75 gallon tank is the figure to plan around.
  • Tub4Two and Companion: 80 gallons.
  • Big4One, Shak, Big4Two and Escape: 100 gallons.
  • A 40 gallon tank: not recommended, since it works only if nothing else draws hot water during the fill.
  • Tankless heaters: rated for at least 11 gallons per minute.

An undersized tank runs out partway through the fill, and an undersized tankless unit delivers the whole fill cooler than you set. Does a tankless water heater work with an Ella walk-in tub? explains the flow side. The setting on the house heater itself is a question for your licensed plumber.

How to Make Sure Your Tub Has Both

  1. Name the model you are considering. Tell your Ella dealer or the team at (800) 480-6850 which tub you have in mind so both features can be confirmed for it.
  2. Ask for a hydro massage package. That is what brings the in-line heater.
  3. Ask for the Ella thermostatic faucet package. That is what brings the TCV. The dual lever 5 piece fast fill faucet and the waterfall wall mount faucet are not thermostatic.
  4. Check your order. Confirm both the in-line heater and the thermostatic package appear on it before the tub is built.
  5. Already own the tub? Look on the deck for a separate temperature handle beside the faucet, or open a ticket at ellasbubbles.com/support with your model and serial number.

Whatever your tub is built with, please check the water by hand or with a thermometer before every bath.

Watch: Ella's Bubbles: TCV Valve Temperature Adjustment with chapters and a full transcript.

Video

Common Questions

Does the in-line heater warm up a cool bath?
No. The in-line heater maintains the temperature of the water you filled with and does not raise it. Your home water heater sets the starting temperature, so begin with a comfortably hot fill.
Do air only or soaking tubs have an in-line heater?
No. The in-line heater comes with every hydro massage package and works with the hydro pump. Air only and soaking tubs have no hydro pump, and the heater cannot be added to those configurations.
What temperature is the thermostatic control valve set to?
The valve arrives factory-set at 100.4 degrees Fahrenheit. It blends hot and cold water to that set point before the water leaves the faucet, and bath water should be kept at or below 100.4 degrees Fahrenheit.
Which Ella models are offered with the thermostatic valve?
The valve comes with the thermostatic faucet package rather than with a particular tub. It is offered on most of our acrylic walk-in tub line, including the Elite, Petite, Royal, Deluxe and Companion, so confirm it on your order.
Are the fast fill and waterfall faucets thermostatic too?
No. The dual lever 5 piece fast fill faucet, the 2 piece fast fill faucet and the waterfall wall mount faucet are not thermostatic. With those, you set the temperature by hand each time you fill.
Can a temperature limit be added to a tub without a TCV?
Yes. If your configuration has no TCV, a qualified contractor can add an external temperature control valve on the hot water line. This may reduce flow and lengthen the fill.

About this guide. Answers in the Ella's Bubbles Ella's Bubbles Walk-In Tub Support Center are compiled from real conversations with owners, our technicians’ notes and the product documentation, then reviewed by our team. Models and options have evolved over the years, so a detail here may differ slightly from yours. If something looks different on yours, send us your serial number and a specialist will confirm it for your model.

Was this helpful?

Did this solve your question?

If not, open a ticket and our team will pick it up from here.

Open a Support Ticket