To replace a faucet cartridge on an Ella walk-in tub, you remove the handle with a 3 millimeter allen wrench, take off the collar that holds the cartridge, lift the old cartridge out, seat the new one and reassemble without over torquing. The exact steps depend on which faucet your tub has: the two-piece fast-fill, the five-piece fast-fill, or a thermostatic faucet, whose procedure is in Temperature Control Valve (TCV) Stuck or Not Mixing: Cleaning the Cartridge and Replacing the Valve. This page gives the steps for each faucet and shows how to tell them apart.
Work Out Which Ella Faucet Is on Your Tub
Ella walk-in tubs are built with one of several faucet packages, and the cartridge sits in a different place on each one. Checking which faucet you have before you pick up a wrench means the right tools and the right part are on hand.
- Two-piece fast-fill faucet. The cartridge sits under the spout handle. The handle is marked red on the left for hot and blue on the right for cold.
- Five-piece fast-fill faucet. This faucet is non-thermostatic, with a hot valve, a cold valve and a diverter, and the water temperature is set at the handles like a conventional tub. The handles carry a red or a blue cap, and the cartridge sits under the handle.
- Thermostatic faucet. A faucet with an Ella Thermostatic Control Valve, or TCV, has the thermostatic valve and two diverters. You set the temperature on a control handle, and the valve blends hot and cold to hold it. The button on that control handle is essential to adjusting the temperature.
If you are not sure which package was built into your tub, your order shows it, and the team can confirm your configuration from your serial number.
One note before you start. The thermostatic procedure begins by shutting off the hot and cold supplies to the tub. The two fast-fill videos start at the handle and do not show that step, so if you are unsure how to isolate your faucet before opening it, call the team at (800) 480-6850 first.
Replacing the Cartridge on the Two-Piece Faucet
The two-piece cartridge replacement video on this page shows the whole job from the top of the spout handle down. These are the steps in the order the video shows them.
- Remove the decorative bolt cover from the spout handle.
- Insert a 3 millimeter allen wrench and loosen the allen bolt, then lift off the spout handle. The video pauses here to show where the allen bolt attaches.
- Unscrew and remove the escutcheon plate.
- Loosen and remove the brass locking collar.
- Lift out the cartridge.
- Set the replacement cartridge in place, making sure its two guide posts line up with the receptacles in the spout housing. The cartridge seats correctly when the two guide posts are in the correct position.
- Replace the brass locking collar and tighten it securely without over torquing.
- Replace the escutcheon plate and hand tighten it.
- Put the faucet handle back onto the top of the cartridge and tighten the allen bolt securely, again without over torquing.
- Replace the bolt cover.
Before you call the job finished, look at the handle markings. The red side should be on the left for hot and the blue side should be on the right for cold. If they are not, correct the handle position before you use the faucet.
Cleaning or Replacing a Cartridge on the Five-Piece Faucet
The five-piece video follows the same idea with one extra tool, a 17 millimeter socket wrench. It also adds an inspection step, so you can see whether the cartridge needs replacing or only needs a clean and a rinse.
- Remove the red or blue cap on the handle.
- Using a 3 millimeter allen wrench, loosen the bolt and then lift off the handle.
- Remove the plastic collar under the handle.
- Using a 17 millimeter socket wrench, loosen and then remove the cartridge.
- Check the cartridge for debris, foreign objects or calcification. If needed, clean it with a soft brush and then rinse.
- Replace the cartridge, either the cleaned one or a new one, and tighten it. Do not over torque.
- Replace the plastic collar.
- Put the handle back on, making sure it is facing in the correct position.
- Tighten the allen bolt firmly without over torquing.
- Replace the colored cap.
Both videos repeat the same caution at every threaded part, the collar, the cartridge and the allen bolt: tighten firmly, without over torquing.
If Your Faucet Is Thermostatic
A thermostatic cartridge is a different part and a different job. In outline, you shut off the water supply to the tub, remove the control handle and cover plate, remove the washers and the escutcheon plate, then unscrew the metal collar and the cartridge. The intake screens and the cartridge are cleaned of calcification, and everything is reassembled without over torquing. Keep track of the button on the control handle, because without it you lose about half of the temperature range. If cleaning does not restore mixing, the cartridge is replaced with a new one, and if the valve itself has failed, the whole TCV is replaced.
The symptom usually tells you whether the thermostatic cartridge is the part to open:
- Water that is either scalding or icy with nothing in between points to a fouled cartridge, as explained in Tub Fills Only Scalding or Only Cold and Will Not Mix to Warm.
- Hot and cold crossing over while the tub is off points first to a worn or fouled thermostatic cartridge and second to the hand shower check valve. The checks are in Why Does the Mixing Valve Cross Hot and Cold When the Tub Is Off?
- Water that comes out hot wherever the dial is set, while the cold line has pressure and the inlet screen is clean, points to the check valve rather than the cartridge. See unlocking the TCV check valve before you order a cartridge.
Parts, Warranty and Who Does the Work
Ella does not send technicians. Removal, cleaning and replacement on site are done by you, a handyman or a local licensed plumber, and free lifetime technical support is available by phone or ticket if a question comes up mid-job. For a replacement cartridge, contact your Ella dealer or the team at (800) 480-6850, or open a ticket at ellasbubbles.com/support with your serial number, a description of the symptom and photos of the faucet. When a part is covered, Ella ships it under the warranty and your plumber does the labor.
The thermostatic valve has its own terms. The TCV carries a 1-year limited warranty, and cartridge fouling from calcium, iron or contaminated water is not covered. An inline filter or mesh must be fitted on the supply and cleaned periodically, which is also what keeps a new cartridge from fouling the way the old one did.
If cleaning a thermostatic cartridge becomes a recurring chore in your area, tech support may suggest replacing the thermostatic faucet with the Ella 5-piece fast-fill faucet. It mixes with manual hot and cold handles and has no thermostatic cartridge to foul, though it does not hold a set temperature on its own.


Watch: Ella's Bubbles: Cartridge Replacement 5 Piece with chapters and a full transcript.
Related Guides
- Why Does My Tub Faucet Drip Constantly and How Do I Fix It?
- Faucet Cartridge Burst and Spraying Water: Shutting It Down and Getting Replacement Hot and Cold Valves
- Why Does My Faucet Handle Keep Falling Off?
Related Videos
