Support Center / Therapies & Operation / How High Should You Fill a Walk-In Bathtub for Soaking?
Back to Therapies & Operation

How High Should You Fill a Walk-In Bathtub for Soaking?

Fill a walk-in bathtub to somewhere between two marks. On a jetted Ella tub the lower mark is just above the highest jets, and the upper limit is the center of the drain handle, which the manuals are firm about: never fill above that point. Between those two marks the choice is yours, and the depth you end up sitting in is the seat-to-overflow figure explained in How do I measure the soaking depth of a walk-in tub?.

The Two Marks That Set Your Fill Height

Every fill decision comes back to two reference points you can see from the seat.

  • The lower mark: just above the highest jets. On a jetted tub this is the least water that makes sense, because the jets need to be covered. Filling only to this level uses the least water and the least hot water.
  • The upper limit: the center of the drain handle. Filling toward the drain handle gives you the deeper soak. Do not go past its center. The manuals are firm that you never fill above that point.

Behind both marks sits the overflow. Water rises to the overflow opening and then runs out, so the overflow carries away anything that rises above it. That is why the published depth on every Ella tub is measured to the overflow and not to the rim. The rim height says nothing about how deep you will sit, and a common mistake is to look at the top of the tub wall and expect that much water.

The same lower mark is used for care. The monthly vinegar flush has you fill the tub with water to one inch above the highest jets before you add the mixture and run the tub for 10 minutes, so it is a level worth learning on your own tub.

Fill Levels and Depth Figures at a Glance

The table gathers the fill marks and the depth figures published for Ella tubs. Where a figure in inches is not published, the cell says so.

Fill mark or tubPublished figureWhat it means for your soak
Just above the highest jetsNot listed in inchesThe lower mark on a jetted tub. Least water and least hot water.
Center of the drain handleNot listed in inchesThe upper limit. Deepest soak. Never fill above it.
Seated tubs, mid-size modelsRoughly 15 to 18 inches, seat to overflowThe real depth of water above the seat when the tub is full.
Deluxe19 inches, seat to overflowA deeper seated soak, with a 47 1/2 inch interior length and a 15 1/2 inch seat length.
LayDown 30x6015 3/4 inches, floor to overflowMeasured from the tub floor because there is no seat. The team has confirmed the water reaches this depth.
Standard bathtubAbout 11 inches soaking depthThe reference point a walk-in tub is compared with.

What the differences mean for you: the fill marks are the same idea on every tub, but the depth they give you depends on the model. On a seated tub the number that matters is seat to overflow, because you are sitting on the seat and the water rises around your torso. On a LayDown tub the number is floor to overflow, because you are lying on the floor of the tub. Either way, a full walk-in tub gives you noticeably more water around you than the roughly 11 inches of a standard bathtub. To see why the spec sheet figure is the true depth, read How Deep Is the Water Really in a Walk-In Tub?.

Why the Water Reaches the Jets Sooner Than You Expect

In a walk-in tub you are already seated while the tub fills. Your body displaces part of the volume, so the level rises around you faster than the empty capacity would suggest. This works in your favor in two ways. You reach the jets sooner than you would in an empty tub, and you can stop the water exactly where the soak feels right, because you are sitting in it the whole time and can feel the level as it climbs.

This is also the reason a single fill height does not suit everyone. The video on this page explains that the overall soaking depth of a walk-in tub is determined by three factors: the interior length of the tub, the length of the seat, and the depth from the top of the seat to the center of the overflow drains. It then adds that the bather's particular size will determine the overall soaking depth. A taller torso sits higher out of the same water, and a shorter bather is covered sooner. Compare the seat-to-overflow figure for your model with your own seated torso, not with your standing height.

The Filling Sequence That Goes with the Fill Height

Fill height only works with the right order of steps, because the door is part of the tub wall. The full routine is in How Do You Use a Walk-In Bathtub Step by Step?, and the part that matters for filling is short.

  1. Step in over the low threshold and sit down on the seat.
  2. Close the door before you turn on the water.
  3. Turn on the faucet and let the tub fill around you.
  4. Watch the level pass the highest jets, then stop anywhere up to the center of the drain handle.
  5. When the bath is over, open the drain, wait for the water to leave, then open the door.

The door stays closed and locked for as long as there is water inside, so never step into a tub that already has water in it. The wait is short. Ella pairs its seated tubs with a fast-fill faucet, rated 16 GPM on the 2-piece set and 18 GPM on the 5-piece set at ideal home plumbing. The glossy acrylic shell acts like an insulator, and optional heated seats add warmth during the fill on models that offer them.

Choosing Your Own Level Between the Marks

Once you know the two marks, the choice comes down to what you want from the bath.

  • For a lighter, quicker bath, stop just above the highest jets. You use less water and less hot water, and the jets are still covered.
  • For the deepest soak, keep filling toward the center of the drain handle and stop there.
  • For anything in between, stop when the water feels right on your body. You are seated in it, so you can judge it as it rises.

If the depth at home does not seem to match the figure for your model, measure from the seat to the center of the overflow with a tape, or from the floor on a LayDown tub, and reach the team through ellasbubbles.com/support or at (800) 480-6850. If you have seen a 15 inch figure and wondered whether it describes a tub's height, Do they make a bathtub that is only 15 inches high? explains that it describes water depth, not the outside height of the tub.

Video

Watch: How to Measure the Soaking Depth of Your Walk-In Tub | Ella’s Bubbles with chapters and a full transcript.

Common Questions

What is the highest level I can fill my walk-in tub?
The upper limit is the center of the drain handle. The manuals are firm that you never fill above that point. The overflow carries away water that rises above it.
How much water do the jets need before I turn them on?
On a jetted Ella tub the lower fill mark is just above the highest jets. Fill to at least that level so the jets are covered. From there you can keep filling up to the center of the drain handle for a deeper soak.
Why does the tub fill faster when I am sitting in it?
You are seated while the tub fills, so your body displaces part of the volume. The level rises around you and reaches the jets sooner than the empty capacity would suggest. It also lets you stop the water exactly where the soak feels right.
Can I fill the tub first and then step in?
No. The door is part of the tub wall and stays closed and locked for as long as there is water inside. Sit down, close the door, and only then turn on the water.
How deep is the water when a seated tub is full?
The published figure is the distance from the seat to the overflow for your model. Across the mid-size seated models it runs roughly 15 to 18 inches, and the Deluxe lists 19 inches. Your own seated torso length decides where that water lands on your body.
Does filling to the rim give me a deeper soak?
No. Water rises to the overflow opening and then runs out, so the rim height does not set the depth. Stay at or below the center of the drain handle and use the seat-to-overflow figure to know your real depth.

About this guide. Answers in the Ella's Bubbles Ella's Bubbles Walk-In Tub Support Center are compiled from real conversations with owners, our technicians’ notes and the product documentation, then reviewed by our team. Models and options have evolved over the years, so a detail here may differ slightly from yours. If something looks different on yours, send us your serial number and a specialist will confirm it for your model.

Was this helpful?

Did this solve your question?

If not, open a ticket and our team will pick it up from here.

Open a Support Ticket