Support Center / Door & Seal / Will an Ella Door Seal Fit Another Manufacturer's Older Walk-In Tub?
Back to Door & Seal

Will an Ella Door Seal Fit Another Manufacturer's Older Walk-In Tub?

No. An Ella door seal is made for an Ella walk-in tub door and will not fit a tub built by another manufacturer, however similar the two tubs look. A door seal is molded to a specific door profile, so the right source for a seal on another company's tub is that manufacturer or a local plumbing supplier. My Tub Is a Different Brand. Will Ella's Bubbles Parts Fit? gives the general answer for all parts, and this page stays with the door seal: why it does not cross brands, how to check whether an older tub is in fact an Ella, and how a seal is matched when it is.

Why a Door Seal Does Not Cross from One Maker to Another

Walk-in tubs from different manufacturers can look alike from across the bathroom, which is why this question comes up so often. Underneath they are not interchangeable. Seals, latches, hoses, jets, pumps and valves differ from maker to maker. A door seal is molded to a specific door profile, and a latch belongs to a specific locking mechanism, so the seal and the door it sits in are designed as a pair.

The video on this page shows how closely the two belong together. Replacing an Ella door gasket means pressing the gasket into the groove of the door channel with a spatula until it is fully seated, with adhesive remover sprayed on to help it slide. At the curved sections of the door, V-shaped relief cuts are made where the gasket bends around the outer edge, straight vertical cuts are made on the inner curves, and a small angled cut finishes the end so the tip slightly overlaps but is fully inserted into the groove. Every one of those steps depends on the gasket matching the channel and the curves of that particular door. A gasket made for a different door has no reason to seat in that groove or follow those curves.

The difference shows even inside the Ella line. Ella tubs span several door families and many production years, and a part that looks right for one family may not fit another. That is why there is no public Ella parts catalog, and why every part is matched from the serial number and photos, not from a list. Across brands the gap is wider still. A door seal for a Safe Step tub or a gasket for an Aston or Jacuzzi walk-in tub comes from those companies, and the Ella team has no way to source another company's components. Does Ella's Bubbles service or sell parts for other brands' walk-in tubs? explains that policy in full.

First, Make Sure the Older Tub Is Not an Ella

Many people who ask this question have an older tub that was inherited or bought used with no paperwork, so the brand was never known. One photo settles it. Pull the removable access panel next to the door away from the frame and photograph the serial label behind it. An Ella serial usually begins with M.

The door itself is the next clue. These door styles point to an Ella family:

  • An inward-swinging brushed stainless steel door with frosted glass.
  • An outward-swinging white U-shape door with a tempered glass panel and three latches.
  • An L-shape outward door with the handle on the front and two latches.
  • An inward acrylic S-shape door.
  • An inward brushed aluminum door.
  • A glass door on a low LayDown tub.

If the door matches none of these and there is no M serial label, the tub is most likely not an Ella. Is My Tub an Ella? Identifying the Brand and Model From Labels, Doors and Faucets Before Ordering Parts goes through each door family and what the numbers on the label mean.

If It Is Another Maker's Tub

Your tub's own manufacturer is the right place to go for a seal matched to its door, and a local plumbing supplier is the other route. Have the brand, the model and any label information ready when you ask, since the seal has to match that door.

Ella's technical support covers Ella tubs, so the team cannot recommend a substitute seal for a door Ella did not build. If you are not sure whose tub you have, the team is glad to look. Send one photo of the outside of the tub showing the door and faucet and one photo of the label behind the panel through ellasbubbles.com/support, or call (800) 480-6850, and the team confirms the brand.

If the Older Tub Turns Out to Be an Ella

Then a door seal is available, and age alone does not rule it out. Replacement parts for Ella walk-in tubs are available and technical support continues for the life of the tub, including legacy models such as the G-305, G-308, G-310, G-311, G-316, Opal, Malibu and S-Class, which go through the same path with the model and serial. A few points apply to an older tub:

  • The seal is matched to your door. The team identifies it from the serial label and photos, because the door families use different doors.
  • Age can affect stock. A serial that indicates 6 or more years of age may point to parts no longer stocked, and the team confirms substitutes.
  • A used tub is still supported. Parts are still available for a tub bought used. The warranty stays with the first purchaser at the original installation address, so parts for a later owner are supplied outside the warranty.
  • For the original owner, the door seal is among the items named in the Lifetime Limited Warranty, which covers parts only. The team verifies coverage for each request.

To request the seal, photograph the serial label, the door and the worn section of the gasket, note where the tub was purchased and whether you are the original owner, and have a street address ready, since parts ship by UPS and cannot go to a PO box. Does Ella's Bubbles Sell Replacement Parts for Walk-In Tubs? lists the full path. Send the request through your Ella dealer, where you purchased, or the team at ellasbubbles.com/support and (800) 480-6850. Ella does not send technicians, so the seal ships to you and a local licensed plumber does the fitting, following the steps shown in the video.

Video

Watch: How To Install a Walk-In Tub Door Seal (Step-By-Step) with chapters and a full transcript.

Common Questions

Can I trim an Ella door seal to fit another brand's door?
No, that is not something the team can support. A door seal is molded to a specific door profile, and the cuts shown in the installation video are relief cuts for the curves of an Ella door, not a way to adapt the gasket to a different door. The manufacturer of your tub is the right source for a seal matched to it.
How do I tell if my older tub is an Ella?
Pull the removable access panel next to the door away from the frame and look for the serial label behind it. An Ella serial usually begins with M. A photo of the outside of the tub showing the door and faucet also lets the team identify the door family.
Where do I get a door seal for a tub Ella did not make?
The original manufacturer of the tub is the right place to ask, and a local plumbing supplier is the other source for seals, latches and valves. Ella supplies parts only for Ella walk-in tubs and has no way to source another company's components.
Is a door seal still available for a discontinued Ella model?
Yes, legacy Ella models go through the same parts path using the model and serial number. A serial that indicates 6 or more years of age may point to parts no longer stocked, and in that case the team confirms a substitute.
Can I get an Ella door seal for a tub I bought used?
Yes, parts are still available for an Ella tub bought used. The warranty stays with the first purchaser at the original address, so parts for a later owner are supplied outside the warranty.

About this guide. Answers in the Ella's Bubbles Ella's Bubbles Walk-In Tub Support Center are compiled from real conversations with owners, our technicians’ notes and the product documentation, then reviewed by our team. Models and options have evolved over the years, so a detail here may differ slightly from yours. If something looks different on yours, send us your serial number and a specialist will confirm it for your model.

Was this helpful?

Did this solve your question?

If not, open a ticket and our team will pick it up from here.

Open a Support Ticket