Centro de soporte / Instalación y nivelación / How Is a Walk-In Tub Installed, and Do I Need a Professional?
Back to Instalación y nivelación

How Is a Walk-In Tub Installed, and Do I Need a Professional?

Actualizado noviembre 2026

Ella's Bubbles manufactures the tub and does not perform installations or send its own technicians, so an Ella walk-in tub is installed by a local licensed plumber and electrician, or by a skilled owner who hires the electrician for the electrical step. Ella always recommends licensed professionals so local codes are followed, but a handyman with real plumbing and electrical experience can do the plumbing side, as Installing It Yourself: What DIY Owners Must Do to Keep Support and Warranty explains. The one step that is never optional is the electrical: the tub must be on dedicated GFCI protected circuits provided, installed and tested by a licensed electrician.

What the Installation Involves, Start to Finish

  1. Inspect and test on delivery. Photograph any damage, record it on the shipper's delivery document and have the driver sign. Whenever possible, fill the tub before it goes inside to check for transit leaks.
  2. Remove every panel before moving the tub. Take off the front apron, access panels and end panel, and lift only by the frame. The air jets on the bottom break off if the tub is dragged or set down on them.
  3. Check dimensions and prepare the subfloor. The floor must be level and able to support the tub, the water and the bather. Set the tub on its adjustable legs and level it until every leg touches the floor with equal weight, because the door only closes into a watertight seal when the tub is truly level. On the Standard and Zen platform the front legs are screwed into the subfloor.
  4. Connect the drains. The dual 2 inch drains connect to the house drain through the T-type fitting. Your plumber can use all four ports or either side and caps the ports that are not used.
  5. Connect the water supply. The faucet ships with two 5 foot supply lines. Ella strongly recommends 3/4 inch shut-off valves near the tub for easy access and future service.
  6. Make the electrical connections. The pumps, heater and other electrical components are certified, clearly labeled at the factory and plug into dedicated GFCI protected receptacles. The tub cannot share a circuit with any other appliance, the breaker box must use GFCI protected breakers, and the more pumps and accessories the tub has, the more dedicated lines it needs. The tub frame and every electrical component carry ground wires and must be properly grounded to local and state code.
  7. Fill and leak test before anything is closed up. Run water, check every connection and run the pumps before walls, trim or access panels go back on.

If you want a shower column, it is fitted before the tub is finally set in place, because the column needs access to the back side of the tub for its supply connection. Where can I buy a walk-in tub shower combo with professional installation? covers that planning point.

Which Steps You Can Do Yourself and Which Need a Licensed Trade

TaskWho can do itWhat to know
Delivery inspection and moving into placeOwner or installerPanels off, lift by the frame only, fill to test for leaks before it goes in
Leveling on the adjustable legsOwner with experience or a plumberEvery leg touching with equal weight, otherwise the door will not seal
Drain and water supply connectionsOwner with plumbing experience or a licensed plumberDual 2 inch drains through the T-type ports, two 5 foot supply lines, 3/4 inch shut-off valves recommended
Electrical circuits and groundingLicensed electrician onlyDedicated GFCI protected circuits, GFCI breakers, proper ground; the electrician's license and insurance go on the activation form
Fill and leak testWhoever did the installBefore walls or panels are closed up
Warranty activation formOwner and installer togetherBoth sign; the installer initials that the tub is level, on a dedicated GFCI breaker, grounded and wired by a licensed electrician

What this means in practice: a confident do-it-yourself owner can handle delivery, leveling, drains and supply lines and then bring in a licensed electrician for the circuits. An owner who is not comfortable with plumbing should hand the whole job to a licensed plumber and electrician. Either way the tub is the same, the parts warranty is the same, and the electrician is part of every installation.

Why Ella Recommends a Licensed Professional

The Lifetime Limited Warranty is a parts warranty no matter who installs, but it excludes improper or negligent installation, and labor, removal, replacement and plumbing or electrical connections are never covered. A licensed professional protects you on both counts. The warranty is also put in force by the 2-page activation form, which must be completed and signed by both you and your installer, with the installer initialing that the tub is level with all legs touching, installed by a licensed electrician on a dedicated GFCI circuit breaker and properly grounded, and supplying the electrician's license and insurance information. Any licensed installer is fine, and certification by Ella is not required.

Labor on an Ella tub is warranted by whoever did the work, never by Ella's Bubbles, so get the labor scope and the installer's own labor warranty in writing before the job starts. My Installer Went Out of Business, Who Does Warranty Repair Labor Now? explains how the two promises differ and why your parts coverage continues even if the installer does not.

Finding an Installer and the Support They Receive

If you do not have a contractor, give the team your full installation address and they will check the installer network near you and help you locate a reputable installer, ideally one who measures the space in person before the order is placed. Ella sends the recommended installer your contact information, the tub specifications and the electrical diagrams for your model, and the installer contacts you directly, visits to measure, and provides an estimate for the work. Getting Installer Referrals and Leads for Your Walk-In Tub describes that process.

Whoever does the work gets free lifetime technical support from Ella by phone, email and live video, along with the manuals and schematics for your model, so prior experience with Ella tubs is not required. The video on this page explains the electrical requirements: dedicated GFCI protected outlets, GFCI breakers in the panel, no shared circuits, and where on the Ella website the electrical requirements for each jetting package are published so your electrician knows how many lines and outlets the tub needs before the first wire is run.

After Installation: Who Handles Problems Later

Once the tub is in, Ella Technical Support diagnoses any problem with you by phone, photos and live video, ships a verified part under the warranty, and a local licensed plumber, electrician or handyman fits it. Nearly every repair is ordinary plumbing or electrical work, so you are never dependent on a specialist. Who Can Come Out and Fix My Walk-In Tub? covers that service model. Before you start the installation, open a ticket at ellasbubbles.com/support or call (800) 480-6850 to arrange live video help for yourself or your electrician.

Video
Chapters in this video
  1. 0:00 Electrical Components Clearly Marked The video explains the electrical requirements for installing an Ella's Bubbles walk-in tub, showing how components are clearly marked and accessible.
  2. 0:31 Dedicated GFCI Protected Outlets The contractor connects the tub to the home's power supply, emphasizing the need for dedicated GFCI protected outlets and breakers.
  3. 0:57 Finding Electrical Requirements Online The video directs viewers to the Ella's Bubbles website to find detailed electrical requirements based on their specific tub model and jetting packages.
  4. 1:28 Plug In and Enjoy After proper installation, the tub is ready to be plugged in, and technical support is available for any questions.

Watch: Ella's Bubbles: Proper Electrical Installation For Your Walk-In Tub with chapters and a full transcript.

Video
Chapters in this video
  1. 0:00 Pre-Installation Checks and Tips Before installation, the video emphasizes checking tub dimensions, inspecting for damage, and leak-testing the tub with water.
  2. 1:34 Dual Drain System Installation The video demonstrates how to install Ella's exclusive dual drain system, showing various configurations and recommending a two-inch house drain.
  3. 3:09 Leveling and Door Alignment The technician levels the tub, ensuring proper door alignment for a leak-proof seal, and advises leaving the door unlocked when not in use.
  4. 3:53 Water Supply and Electrical Connections The video shows connecting fast-fill faucets with three-quarter inch supply lines and emphasizes using GFCI-protected outlets and breakers for electrical connections.
Video
Chapters in this video
  1. 0:00 Important Installation Disclaimer This video is for educational purposes only and requires licensed contractors to follow local building codes.
  2. 0:16 Ella's Tecnología de doble desagüe Ella's walk-in tubs feature dual 2-inch drains for fast, efficient drainage and overflow protection.
  3. 1:47 Fast Fill Faucet Sets Ella offers five-piece or two-piece fast-fill faucet sets, each with an extendable hand shower and five-foot supply lines.
  4. 2:18 Electrical Components And Leveling Electrical components are clearly marked and accessible, and the tub must be perfectly level before testing.

Preguntas comunes

Can I install an Ella walk-in tub myself without a contractor?
Many owners do, and the honest test is whether you are comfortable with plumbing and electrical work. Ella always recommends licensed plumbers and electricians so local codes are followed, and the GFCI protected circuit must be provided, installed and tested by a licensed electrician even on an otherwise do-it-yourself job.
Does Ella's Bubbles send its own installers to my home?
No. Ella manufactures the tub and does not perform installations or send technicians. A local licensed plumber and electrician do the work, and Ella supports them with free lifetime technical support by phone, email and live video.
Does my installer need a special walk-in tub certification?
No. Any licensed installer is fine and certification by Ella is not required. The installation is ordinary plumbing and electrical work, and the team supplies manuals, schematics and live help to any licensed professional.
What electrical work does a walk-in tub installation require?
The pumps, heater and controls plug into dedicated GFCI protected receptacles on GFCI protected breakers, and the tub cannot share a circuit with any other appliance. The number of dedicated lines depends on the jetting package, and the tub frame and components must be properly grounded by a licensed electrician.
Will installing the tub myself void my warranty?
The Lifetime Limited Warranty is a parts warranty no matter who installs. It excludes improper or negligent installation and never covers labor, so the installation must be level, watertight, on dedicated GFCI circuits installed by a licensed electrician, with nothing cut or modified, and the activation form must be completed and signed.
How do I find a licensed installer near me?
Give the team your full installation address at ellasbubbles.com/support or (800) 480-6850 and they will check the installer network near you. The recommended installer receives your contact details, the tub specifications and electrical diagrams, then contacts you to measure and provide an estimate.

About this guide. Answers in the Ella’s Bubbles Support Center are compiled from real conversations with tub owners, our technicians’ notes and the product documentation, then reviewed by our team. Tub models and options have evolved over the years, so a detail here may differ slightly from your exact tub. If something looks different on yours, send us your serial number and a specialist will confirm it for your model.

Did this solve your question?

Si no, abre un ticket y nuestro equipo se encargará a partir de aquí.

Abrir un ticket de soporte