Support Center / Therapies & Operation / How Long Does Auto Purge Run After a Bath, and Can I Change It?
Back to Therapies & Operation

How Long Does Auto Purge Run After a Bath, and Can I Change It?

Auto Purge runs for 120 seconds, and it starts on its own about 20 minutes after the air pump is switched off. The timing is built into the air massage system, so there is no button for it and no way to retime, shorten or cancel it. What you can choose is the moment the countdown begins, because it always starts when the air massage is turned off. The background on the cycle is in What Is Auto Purge on a Walk-In Tub?, and this page focuses on the timing and what you can and cannot do about it.

The Two Numbers Behind Every Purge

Two figures describe the whole cycle, and they are the same on every Ella tub with the three-speed air massage.

  • The wait: about 20 minutes. The countdown begins when the air pump is turned OFF. It does not begin when the pump is turned on, and it does not depend on whether the tub has been drained. Some printed manuals say the purge fires after the pump is turned on, which is a known wording error.
  • The run: 120 seconds. The air pump starts by itself, blows for two minutes, and stops by itself.

The reason for both numbers is simple. After an air bath, a little water flows back into the air piping and the jets on the floor and seat. If that water sat there, it could grow mold and mildew. The purge pushes it back out through the air jets so the lines are left dry. It behaves the same way whether the tub is full, empty or still filling, and water at bath level does not interfere with it.

Only air massage tubs purge. Any tub ordered with the three-speed air massage has the cycle, whether the air system came alone, as Hydro plus Air, or in a triple package. Hydro-only and soaking tubs have no air blower and therefore no purge cycle. Hydro jets drain themselves as the tub drains and never cycle on their own.

Can the Timing Be Changed, Shortened or Switched Off?

No. The purge is fully automatic, and each part of that answer is worth spelling out.

  • There is no purge button. The deck buttons or the touchpad run the hydro, air, microbubble and light. None of them starts, stops or adjusts the purge.
  • The wait cannot be retimed. The roughly 20 minute delay is not an owner setting.
  • The run cannot be interrupted. Once it starts, the cycle runs its 120 seconds and stops on its own.

None of this is a problem for the bather. If the purge starts while you are still sitting in the tub, there is no harm in staying where you are and no need to get out. If you would like to leave while it runs, just drain and exit normally. The tub will sound like it is still running, but it is only the purge finishing its job.

What You Can Control: When the Countdown Starts

Because the countdown is tied to the moment the air pump is switched off, your use of the air button decides when the purge arrives. Running the air for a moment before the bath, perhaps to test it, restarts the countdown, and the purge can then land in the middle of the soak. That exact situation is covered in Why Did the Auto Purge Come On While I Was Filling the Tub?. To keep the purge after your bath rather than during it, follow this sequence.

  1. Leave the air button alone while the tub fills. Even a brief on and off starts a countdown.
  2. Turn the air massage on once the tub is filled.
  3. Step through the speeds as you like. The first press is high, the second is medium, the third is low, and the fourth press turns the system off. On the digital touchpad, hold the air icon for two seconds to stop it.
  4. Turn the air off when you are done bathing, so the purge arrives about 20 minutes later, after you have finished.
  5. If a second bath begins less than 20 minutes after the first one ended, expect the purge from the earlier bath to land during the second one, and simply let it finish.

Is What You Are Hearing the Normal Cycle?

One run of 120 seconds, about 20 minutes after the air was switched off, is the whole normal pattern. Anything that repeats or does not stop is something else. Use the table to match what you notice.

What you noticeWhat it isWhat to do
One burst of air for 120 seconds, about 20 minutes after the air pump was switched offThe normal Auto PurgeLet it finish. It stops on its own.
The purge arrives while the tub is filling or in the middle of the bathThe scheduled cycle from an earlier air shutoffLet it run its two minutes and carry on bathing.
The two minute cycle comes on three times in an hour with no one touching the buttonsA stuck push button or a control box fault, not the timerCheck for a push button stuck in the down position, then run the control box reset.
The air turns on every 10 minutes or every 1 to 2 hoursA stuck push button or a control box faultDisconnect the button's red air tube at the control box so the button pops up, then reconnect the tube.
The blower runs continuously instead of stopping after 120 secondsUsually a stuck relay or the control boxSwitch the tub off at the breaker and open a ticket.
No purge at all on a hydro-only or soaking tubExpected, since there is no air blowerNothing to do.

The difference that matters is count and length. A single two minute run after an air bath means the system is doing exactly what it was built to do, and no ticket is needed. Repeated starts point to a chrome push button that sits down instead of popping back up, which keeps sending its air signal to the control box, or to the control box itself. Also note where the air pump is plugged in: a pump plugged straight into the wall instead of into the top of the control box runs whenever it has power. The step by step checks are in Why Did My Walk-In Tub Turn On by Itself?. If the starts continue after the button release and the reset, open a ticket at ellasbubbles.com/support or call your Ella dealer or the team at (800) 480-6850 with your serial number, the times the cycles started, and a photo of the blue control box showing where the pumps and air tubes are plugged in.

Power, the Breaker and the Other Pumps

Turning the air off at the deck does not skip the purge. An air massage tub will still run its two minute Auto Purge about 20 minutes after the air was switched off, as long as it has power. The tub's dedicated GFCI breakers remove all power from the tub, and that step belongs to emergencies and to a blower that will not stop, as explained in How Do I Turn the Jets Off in an Emergency?. For everyday bathing, leaving the tub powered lets the purge do the drying it exists to do.

The purge is also the only automatic cycle of its kind on the tub. The microbubble pump has no timer and no automatic shutoff, so it runs until you switch it off, which is covered in Is There a Time Limit on How Long the Microbubble Pump Runs?. If you hear a pump start by itself, the air system is the one to think about first.

What the Video Shows

The video on this page introduces the three-speed air massage, available with digital or push button controls, and states that Auto Purge activates 20 minutes after the tub is turned off to clear leftover moisture and help prevent mold and mildew. An older Ella video mentions a 15 minute wait. The correct figure is about 20 minutes after the air pump is turned off, followed by the 120 second run.

Video

Watch: Walk-In Tubs Featuring Three Speed Air Massage & Auto-Purge Technology | Ella’s Bubbles with chapters and a full transcript.

Video

Common Questions

How many minutes after my bath does Auto Purge start?
Auto Purge starts about 20 minutes after the air pump is switched off. The countdown is tied to the air massage being turned off, not to the tub being drained, so it can begin while water is still in the tub.
How long does the Auto Purge cycle keep running?
The cycle runs for 120 seconds, which is two minutes, and then stops on its own. If the blower keeps running instead of stopping after 120 seconds, switch the tub off at the breaker and open a ticket at ellasbubbles.com/support.
Can I stop Auto Purge once it has started?
No. The cycle cannot be interrupted, and there is no button for it on the deck or the touchpad. It ends by itself after 120 seconds, and it is safe to stay in the tub or to drain and exit normally while it runs.
Can the 20 minute delay be set to a different time?
No. There is no way to retime the purge. What you can do is choose when the countdown begins, by turning the air massage on once the tub is filled and turning it off when you are done bathing.
Why did the purge start while I was still bathing?
The air massage was most likely switched on and off shortly before or early in the bath, which started the 20 minute countdown. A previous bath that ended less than 20 minutes earlier has the same effect. Let the cycle finish its two minutes and carry on.
Does a hydro-only walk-in tub have an Auto Purge cycle?
No. Only tubs with the three-speed air massage purge, because the cycle uses the air blower. Hydro jets drain themselves as the tub drains and never cycle on their own.

About this guide. Answers in the Ella's Bubbles Ella's Bubbles Walk-In Tub Support Center are compiled from real conversations with owners, our technicians’ notes and the product documentation, then reviewed by our team. Models and options have evolved over the years, so a detail here may differ slightly from yours. If something looks different on yours, send us your serial number and a specialist will confirm it for your model.

Was this helpful?

Did this solve your question?

If not, open a ticket and our team will pick it up from here.

Open a Support Ticket