You do not need a house drain connection on both sides of an Ella walk-in tub. You can connect the house drain on one side and cap the unused ports with the end caps included with the tub. Connecting all four ports gives the fastest possible drainage, and your installer determines which setup is most efficient for your home. The hardware behind that choice is explained in What Is a 4-Port T-Type Drain on a Walk-In Tub?.
Two Floor Drains, Four Ports, One House Connection
The question usually comes from mixing up two different things: the drains you see in the tub floor and the ports underneath them. Most Ella walk-in tubs use Dual Drain Technology, which means two oversized 2 inch gravity drains in the footwell, each with its own deck handle. Under the tub, each of those drains drops into a T-type PVC body with 2 inch ports, for four 2 inch ports in total.
Both floor drains always do their job. The two drains are joined together under the tub, so your plumber brings one house connection to the tub and caps the ports that are not used. What you are choosing is how many of the four ports carry water to the house drain, and on which side. The ports exist so the drain line can leave in whichever direction your plumbing needs, from the left or from the right. A plumber who assumes that two drains need two house connections is planning more work than the tub requires. One P trap serving both tub drains is typical.
The Connection Options Side by Side
These are the setups the published sources describe. Figures appear only where a source states them.
| Setup | Ports connected | Ports capped | What it means |
|---|---|---|---|
| Maximum flow | All four 2 inch ports | None | The fastest possible drainage on a dual-drain tub |
| Most common build | Two of the four ports, on the convenient side | The unused ports, with the two end caps that ship with a dual-drain tub | One house connection on the left or the right, whichever suits the home |
| Single port | One port | Every unused port | Still works; even with a single drain connected to a 2 inch floor drain, the tub empties in about two minutes |
| Standard, Standard60, Zen, Zen60 and Flow | One of the two connectable ports on the single 2 inch drain | The unused side, with the one end cap supplied | A single-drain tub, so there is only one side to choose |
What the differences mean for you: every row is a correct installation, so capping one side is a choice and not a compromise you have to apologize for. The more ports that carry water, the faster the tub empties, and because you sit in the tub until it drains, that speed is a comfort feature. The average drain time for a typical dual-drain tub is approximately 80 seconds under ideal conditions, and your own time depends on your model's capacity, how many ports are connected and your house drain. If your house drain can be reached from both sides without a long run and extra elbows, all four ports is the best result. If it cannot, two ports on the convenient side is the build most homes end up with.
Capping the Unused Ports the Right Way
Whatever is not connected is open pipe under a tub full of water, so every unused port has to be closed. The caps are the white PVC caps that ship in the tub's parts box, and they are glued in place with PVC cement, the same way the connected ports are joined with standard PVC fittings. Ella recommends the original PVC caps cemented on and does not recommend a rubber cap. The details are in Do I need to glue the drain caps if only using two drains?.
- Before your installer starts, count the end caps: two for a dual-drain tub, one for the Standard family.
- If a cap seems missing, look inside the tub and under the frame first. Every small part is individually wrapped, boxed and packed there, and a small wrapped part is easy to overlook in the crate.
- After installation, make sure every unused port is capped and every joint is snug.
Choosing the Side and Planning the Run
Your installer picks the side by looking at where the house drain is. A few published points help that decision:
- A 2 inch house drain is recommended for the fastest emptying. A 1.5 inch house drain also works with a standard 2 inch to 1.5 inch reducing fitting ahead of the P trap, as My House Drain Is 1.5 Inches. Will the 2 Inch Tub Drain Work? explains.
- A Y fitting is preferred over a T, because fewer sharp turns move water faster. Keep the run short and use the fewest turns you can.
- If the house drain is on the far side or in the center, there is roughly 3 inches of clearance under the tub for 2 inch PVC, so the plumber can run the drain to either side.
- The PVC pipe from the tub to the house drain is not included, and the house drain should be tested for free flow before the tub goes in. Two drains cannot fix a restricted house line.
- A flexible P trap or a no hub coupling at the joint under the tub lets the tub be removed later without cutting pipe.
Not every Ella tub has ports to choose between. Dual Drain Technology is standard on the stainless-door, Ultra, outward-swing (except the Front Entry), two-seat and Transfer families, listed model by model in What Is Dual Drain Technology on a Walk-In Tub?. The Front Entry uses a single 2 inch 2-port drain, and the LayDown tubs use a threaded brass drain with a supplied elbow, so the PVC cap question does not arise there.
What the Videos Show
The dual drain video shows a house drain connected to all four ports for maximum draining capacity, then a connection on the left side of the tub and a connection on the right side. It states that your installer determines which side is best and most efficient, and that ports not being used can be sealed off on either the left or the right. The installation guide video shows the dual 2 inch drains with four ports from underneath, the unused ports capped off, and the house drain joined to the T fitting on either side using all four ports or just two.
Once the tub is in service, open both drain handles completely for full speed and close both completely to hold water. The handles also act as air vents, which helps the water leave without air pockets. The system is gravity driven, so there is no drain pump to fail.


Watch: Walk-In Tub Installation Guide & Tips, Easy Process | Ella’s Bubbles with chapters and a full transcript.
Related Videos

