Ella's Bubbles: 4 Fold Glass Door Installation Video

here's some installation tips on how to install the Ella four-fold glass shower screen unpack your glass screen carefully and make sure all parts are accounted for carefully unbox and unwrap the screen we recommend setting the screen on the floor bottom side up at this point measure where your wall channel will be positioned measure carefully and set it at perfect level Mark the drill holes drill carefully insert and tap in anchors and then carefully tighten the screws making sure to leave a little lag and then hand tighten the final few turns making sure not to over torque place the gasket into the channel at the bottom of the shower screen if needed use a little silicone lubrication to help it slide in the gasket is longer than the door so there will be excess material that will be cut later leave 75 millimeters out at the wall end cut as seen here tie a knot with a loose end and place that knot into the space in the plastic Corner this will anchor the gasket remove the screw at the opposite bottom front side of the screen pull the gasket down the channel away from the open end of the door so you can place the end cap molding onto the vacant space and using the same screw secure the end cap molding the end caps are all included in the parts and accessories bag draw the gasket through the end cap insert one half of the seal end cap on one side of the gasket and then do the same on the other side this will anchor the gasket on the open side of the door glue both end cap and seal cap onto the molding and then trim the excess gasket place the Chrome knobs onto the glass screen making sure the rubber gaskets are in place tighten firmly but don't over torque at this point you can place the screen onto the channel to determine the proper height and the proper level proper height and level is critical for the correct function of the bottom gasket if the door is too low it will damage the gasket if the door is too high it will cause a leak the gasket should brush the tub deck lightly and evenly the door can be adjusted to compensate for bathroom walls that might not be square by simply moving the door inside the wall Channel foreign perfect height and level Mark the drill holes through the pre-drilled holes on the wall Channel drill the holes as marked and then re-secure the door onto the wall Channel using the screw snap cap bases attach the door to the channel tighten securely but don't over torque attach the decorative screw snap caps the final result should look like this finally snap on the hinge screw caps on the top of the screen a thin bead of silicone caulk must be placed between the wall Channel and the wall to prevent leaks the horizontal gasket should rest evenly on top of the tub deck creating a nice seal